How to Replace a Nissan Juke Spare Key

Nissan Juke is an attractive and fun hatchback that features a unique engine configuration. It's noisy, but still a blast to drive.

The key fob battery on your nissan juke needs to be replaced every two years or so, or if it's low. It's easy to replace at home, but you'll require a few tools.

Dead Coin Battery

If the key fob in your Nissan Juke has stopped working, check the battery for coins. It may be dead and need to be replaced, which is a straightforward fix that takes just less than a minute. Flip the fob upside down so that you can access the tiny latch/release located at the back. Take out the old battery and then put in the new one, making sure it's facing downwards in the fob and line up the two halves of fob in a carefully.

If the fob has been exposed to water, it needs to be cleaned before putting the new battery in. It is possible to clean the fob with isopropyl electronic cleaner and a towel. Then allow it to dry completely prior to installing the battery.

To start the car the key fob has to also be paired to the car. This can be accomplished using the instructions in the owner's guide or an OBDII scan. If the key fob is not been paired, this is the most likely cause of why it stopped working. A damaged chip in the fob may cause it to stop working however this is not a common occurrence. In this situation the need for a new receiver module might be needed. If this is the situation, it will have to be replaced by a skilled technician.

Water Damage

The key fobs run on batteries and the batteries must be replaced every two years, or as soon as your car stops responding when you press the "start" switch. The key's rubber seals protect them from water, however submerging a key fob into the ocean or in pool water can damage the chip's electronic. If this is the case you'll need an alternate key from Nissan or locksmith.

It's possible that the computer lost connection with the key fob and this could be due to a variety of reasons. This can be fixed by restarting the car. If the "Key ID error" message continues to appear then you must contact nissan smart key replacement for assistance.

The three most common reasons for this are dead battery on the key fob, a non-programmed key, and a damaged or faulty key fob. The first two are fairly simple to fix, while the latter is a bit more difficult to fix immediately, but it can usually be fixed by a little patience. WhoCanFixMyCar lets you compare nissan car key replacement price Key Replacement prices in your local area and then book your repair. It only takes minutes, and you can even read customer reviews from local garages, Nissan car mechanics and dealerships before deciding.

Faulty Chip

The key fob on your Nissan Juke contains a special chip that sends a message to the vehicle whenever you turn it. If the chip is defective it could cause the key to stop working. If this is the case the issue can be resolved only by replacing the key. Your Nissan Juke key may be damaged due to several reasons, including water damage or a dead coin-battery.

Examine the chip for water damage if your key fob has stopped working after a wash or bath. Make sure the retaining clips on the chip are tight. Also, make sure the chip isn't in contact with water. If you see any signs of water damage, try taking off the battery, then wiping the electronic component using isopropyl alcohol or electronic cleaner.

If the chip is damaged If the chip is defective, you must visit your local locksmith or dealer. To locate a replacement, they will need the year, make and model of your car. Also, you will need to record the VIN (Vehicle Identification Number) to ensure that the dealer or locksmith can identify the key you own. This will enable them to locate the correct key code and make sure that they are cutting the right one.

Faulty Receiver Module

The key fob sends radio frequency signals to your car, enabling it to perform a number of functions. The key fob can unlock your trunk while you hurry with your groceries to the car or even start your car by pressing an icon on the fob. It can also open your windows and turn on the horn when you accidentally lock the keys inside your car.

If the key fob does not function, it could be due to a glitch in the receiver module. The receiver modules are tuned so that they can pick up specific frequencies which correspond to the signals transmitted by Nissan key fobs. A malfunctioning receiver module can stop your car from responding to the signal generated by the Nissan key fob.

It is always a good idea to have an extra Nissan key fob in the event that your original key gets lost or breaks. A locksmith or dealer can program a spare key to work with your nissan micra replacement key. This will allow you to avoid the hassles of losing your keys or locking them in your car.

If your Nissan key replacement cost (http://www.stes.tyc.edu.tw/) Juke key fob has been exposed to clean water from the tap or rain it is possible to have the issue solved by cleaning it with isopropyl alcohol or an electronic cleaner. If the chip has fried, you'll need to purchase the new keyfob, which can be coded for your vehicle by a dealer or locksmith.