Peugeot 308 Key Fob Problems and How to Fix Them

If your peugeot 308 key fob - visit the site, has stopped working after a few days it could be due to a dead battery in the coin or water damage, receiver module issues or a faulty electronic chip. Luckily these are all easy to fix and you'll be able to get your car back to normal in no time!

The key blade can become worn-out and cause an unusable car key. You can easily fix this problem by visiting your local Car Key Man Auto Locksmith to have a new blade fitted.

Battery

The key fob in your Peugeot 308 may die or become weak enough to not send a strong signal. The key fob might stop working and prevent you from locking or unlocking your doors, or even starting the engine. To fix this, you'll need to replace the battery in the key fob.

You can purchase a new battery at an auto parts shop, or at your local hardware store. When you buy the battery, make sure that it's brand new and hasn't been sitting on the shelf for too long. A new battery has more capacity and will send a stronger signal your vehicle.

After replacing the battery If you have a new battery, try unlocking and locking the doors of your peugeot 308 key replacement with the key fob. If the doors do not unlock it is most likely with the car's receiver module, which can be reprogrammed by your local Peugeot dealer.

The chip inside the key fob could also be damaged. It's possible to harm your key fob if you drop it on the ground, or expose it to water. Rubber seals that protect your chip from moisture could get worn out over time. This is especially the case if you expose your key fob to water for long periods of time, such as submerging it in the ocean. To prevent this from happening, it's important to protect your key fob from moisture and not let it come into contact with water.

Water Damage

Don't let go of your key fob when it gets wet, no matter if you dropped it into the pool or stumbled into a Puddle. The key fob is protected by rubber seals, but prolonged exposure to water may cause damage to its electronic chip. Water is a good conductor, and any water that gets inside the key fob will trigger a series short circuits that eventually destroy the electronic chip. After removing the battery, clean its contacts with isopropyl Alcohol and dry it completely before putting it back into.

Your Peugeot 308 may not start because of a dead battery. If you have a spare vehicle, jumper cables can be used to get the engine going again. If the battery is damaged it is required to replace it.

A bad receiver in the car can also prevent it from receiving the signal from the key fob. The key fob might be damaged or there could be a problem with the antenna, wiring or even the key fob itself. It might be necessary to program a new keyfob for your vehicle if using one. If you are unable to solve the issue, contact a professional technician. A technician who is trained in the field will be able to diagnose the problem quickly, and fix the issue immediately.

Radio Interference

Interference can result in symptoms such as a key fob that's not being recognized or has a limited range. This is either radiated or conducted, with the former being caused by power supply cables and speakers wiring that are too close to electrical components. In general, rerouting cables and moving them away from these components can solve the issue.

It's unlikely that someone is watching your key fob signals to steal your car, however it's possible that the signal has been masked by radio frequency interference. Luckily, this is a simple issue to fix.

If your key fob not being recognized, try using an entirely new battery. Also, ensure that the battery you are using is the correct size and type. Batteries of the wrong size can damage your fob.

These devices may interfere with the key signal if they operate on the same radio frequency. Beware of attaching these devices to your key fob.

Pairing Issues

The remote keyless entry system is a receiver that receives radio frequency signals from the key fob. You will not be able start your vehicle if the receiver is not functioning properly even if your key fob works and can be reprogrammed. This issue can be caused by a variety different ways, such as the battery of the coin-cell being dead or water damage. The receiver could be malfunctioning because of an internal or software issue or damage to the key itself.

The battery inside your peugeot 3008 key programming 308 keyfob is likely to have been drained. This battery can be easily replaced, but you must make sure that it is the correct battery for your keyfob. Using an incorrect battery could cause further issues with the key fob, therefore it is best to choose the original battery or an alternative that is similar in size, voltage and specification.

Another reason that the reason why your peugeot boxer key fob programming 308 key fob might not be working is because it is connected to another vehicle. You may have accidentally given your key fob a friend or the key was used to unlock other vehicles. This can be resolved by reprogramming the fob using an OBDII scanner. This tool will usually ask you for specific information regarding your vehicle, like the VIN or engine type, and it's crucial that you enter this information correctly.